DataCard CD800 User Manual page 108

5.
Load the new roll of laminator overlay
material.
A.
B.
C.
6.
Close the laminator cartridge gate (f).
Push it in until the latch clicks in
place (g). Make sure that the overlay
material is not pinched by the cartridge
gate.
7.
Replace the loaded laminator cartridge
in the printer.
8.
Remove the L2 (orange) cartridge, if
installed, from the laminator.
9.
Repeat steps 3 through 7 to load the
overlay onto the L2 cartridge.
10.
Close and lock the laminator access door.
A-10
Put the blue supply spool on the
blue supply spindle of the cartridge
(c). The overlay supply roll can go
on only one way and only fits on
the correct spindle.
Put the empty silver take‐up spool
on the silver take‐up spindle (d).
Turn the take‐up spool clockwise to
remove slack from the material (e).
The overlay material loads in an
S‐shape.
Make sure that the overlay material
is between the guides on both the
take‐up and supply sides of the
cartridge.
CLM Laminator