Table of Contents
Advertisement
Faxing
Connecting to an analog telephone line
If your telecommunications equipment uses a US‑style (RJ11) telephone line, then follow these steps to connect the
equipment:
1
Connect one end of the telephone cable that came with the printer to the printer LINE port .
2
Connect the other end of the telephone cable to an active analog telephone wall jack.
Connecting to a DSL service
If you subscribe to a DSL service, then contact the DSL provider to obtain a DSL filter and telephone cord, and then
follow these steps to connect the equipment:
1
Connect one end of the telephone cable that came with the printer to the printer LINE port .
2
Connect the other end of the telephone cable to the DSL filter.
Note: Your DSL filter may look different than the one in the illustration.
3
Connect the DSL filter cable to an active telephone wall jack.
Connecting to a PBX or ISDN system
If you use a PBX or ISDN converter or terminal adapter, then follow these steps to connect the equipment:
1
Connect one end of the telephone cable that came with the printer to the printer LINE port .
2
Connect the other end of the telephone cable to the port designated for fax and telephone use.
Notes:
•
Make sure the terminal adapter is set to the correct switch type for your region.
•
Depending on the ISDN port assignment, you may have to connect to a specific port.
•
When using a PBX system, make sure the call waiting tone is off.
2
1
3
91
Advertisement
Table of Contents
