Removing/Installing The Rear Panel Assembly - Sony HXCU-100 Service Manual

3. Disconnect the harness from the connector
CN9 on the CN-3081 board.
4. Remove the UL tape and release the har-
ness from the harness clamp.
5. Remove the three screws and remove the
fan duct.
6. Remove the DC fan from the fan duct.
7. Remove the fan cushion from the DC fan.
8. Install a new DC fan by reversing the steps
above.
n
Carefully install the new DC fan confi rm-
ing the orientation of the label side and the
harness shown in the fi gure.
5-3. Removing/Installing the
Rear Panel Assembly
1. Remove the front assembly.
(Refer to Section 5-1.)
2 Remove the top cover.
(Refer to Section 5-2.)
3. Remove all the screws marked with
the rear panel assembly.
. Screw (PSW3 x 6) x13
. Screw (P2.6 x 5) x6
. Hexagon screw x8
4. Disconnect the fl exible card wire from the
connector CN10 on the SDI-97 board.
n
Be careful not to bend the fl exible card
wire. This shortens the wire life.
5. Disconnect the harness from the connector
CN3 on the CN-3082 board.
6. Disconnect the harness from the connector
CN8 on the CN-3081 board, and remove
the rear panel assembly.
7. Install the removed parts by reversing the
steps above.
5-2 (E)
Fan cushion
UL tape
on
SDI-97 board
DC fan
Label side
CN9
CN-3082 board
CN-3081
board
CN8
CN10
Rear panel assembly
Remove all the screws marked with
PSW3 x 6
Fan duct
Harness clamp
CN-3081 board
CN3
.
HXCU-100