Video Signal System; Input/Output Signal Selection; Signal Phase Adjustment; Adjusting Sync Signal Phase - Sony HXCU-100 Service Manual

3-4. Video Signal System

Video signals of this unit and the equipment used for a camera system were adjusted to the specifi ed
levels in the factory shipping process.
Before starting operation, check the signal levels between equipment and adjust them, if necessary.

3-4-1. Input/Output Signal Selection

Select a signal of the input/output connector on the rear panel according to the video system to be imple-
mented.

3-4-2. Signal Phase Adjustment

Adjust signal phases of the unit.
Before starting this adjustment, input the following sync signals to the unit and equipment used.
REFERENCE connector
Input the HD tri-level sync signal or black burst signal.
HD tri-level sync signal: 0.6 Vp-p
Black burst signal: 40 IRE (0.3 Vp-p)

Adjusting Sync Signal Phase

Adjust the sync signal phase with S02:GENLOCK PHASE of the SYSTEM OPERATION menu so that
the output signal phase matches the phase of the reference signal.
3-8 (E)
HXCU-100