Installing The Hkcu-Fp1 - Sony HXCU-100 Service Manual

1-4. Installing the HKCU-FP1

1. Remove the front assembly.
(Refer to Section 5-1.)
2. Connect the fl exible card wire of the HKCU-FP1
to the connector CN2 on the SY-364 board.
n
Be careful not to bend the fl exible card wire.
This shortens the wire life.
3. Install the HKCU-FP1 with fi ve screws with
stopper.
4. Check that the HKCU-FP1 is recognized
correctly on the status screen.
n
Front Panel on the screen shows the status of
the HKCU-FP1.
HXCU-100
Screws with stopper
HKCU-FP1
CN2
SY-364
board
Screws with stopper
1-7 (E)