Cn-3081 Board - Sony HXCU-100 Service Manual

6. Loosen the cable clamp and disconnect the
harnesses from the connectors CN3 and
CN5 on the CN-3080 board.
7. Remove the nut and disconnect the harness
(WF-REMOTE).
8. Install a new CN-3080 board by reversing
the steps above.

5-5-3. CN-3081 Board

1. Remove the front assembly.
(Refer to Section 5-1.)
2. Remove the top cover.
(Refer to Section 5-2.)
3. Remove the rear panel assembly.
(Refer to Section 5-3.)
4. Remove the SDI-97 board.
(Refer to Section 5-5-12.)
5. Remove the VIF-39 board.
(Refer to Section 5-5-14.)
6. Disconnect the harnesses from the connec-
tors CN5, CN6, CN9, and CN10 on the
CN-3081 board.
7. Disconnect the fl exible card wire from the
connector CN7 on the CN-3081 board.
n
Be careful not to bend the fl exible card
wire. This shortens the wire life.
8 Remove the CN-3081 board from the
connector CN5 on the MB-1124 board.
9. Install a new CN-3081 board by reversing
the steps above.
5-6 (E)
CN-3080 board
CN3
Cable clamp
MB-1124 board
CN5
CN5
Harness
(WF-REMOTE)
Nut
CN6
CN7
CN5
CN10
CN9
CN-3081 board
HXCU-100