Sony HXCU-100 Service Manual page 25

6. Set the unit in the rack while pressing the
inner rail stopper into the outer rail as far as it
will go.
m
. This rack mounting work must be done by
two or more workers so as not to hurt the
worker s waist.
. Failure to tighten the rack angle screws
may cause the unit to slide and fall from the
rack, resulting in injury. After the unit has
been mounted, be sure to tighten all the
screws.
. When setting and drawing the mounted
unit, be careful not to catch your fi ngers by
the rails.
. If balance is lost when mounting and
removing the unit, it may fall, resulting in
injury. Mount or remove the unit carefully
maintaining a stable posture.
7. After the unit has been set in the rack, secure the
unit to the rack with four screws (PSW5 x 25).
HXCU-100
Rack
Stopper
Inner rail
Stopper
PSW5 x 25
PSW5 x 25
1-17 (E)