Fixing Delivery Assembly - Canon imageCLASS D600s Service Manual

5.2.4

Fixing Delivery Assembly

General conditions
Paper
Paper
Fixing locking roller
Fixing inlet guide
Roller (fixing delivery system)
Delivery sensor
Gear (in drive assembly; for fixing locking roller, delivery roller drive)
COPYRIGHT © 2001 CANON INC.
Chapter7C.p65
1) Is the delivery roller rotating normally?
YES: Go through steps 2) to 7).
NO: Go to step 8).
2) Is the paper curled or wavy?
YES: Replace the paper, and advise the user on the correct method of
storing paper.
3) Try paper of a recommended type. Is the problem corrected?
YES: Advise the user to use recommended paper.
4) Execute fixing locking roller cleaning. Is the problem corrected?
(See 4.1 of Chapter 6.)
YES: Advise the user to clean the component on a periodical basis.
5) Is the fixing inlet guide soiled, or is there foreign matter?
YES: Clean it. If there is any foreign matter, remove it.
6) Is the surface of the following rollers normal?
• fixing locking roller
• delivery roller
NO: Clean the soiled component. If scratched, replace it.
7) Check the delivery sensor. Is the problem corrected? (See 4.2.9 of
this chapter.)
NO: Replace the delivery sensor.
8) Is any of the gears of the drive assembly (used to drive the fixing
locking roller, delivery roller) cracked or damaged?
YES: Replace the damaged gear.
CANON imageCLASS D600s/PC1060s/PC1200s/iR1200s REV. 0 SEPT. 2001
83
CHAPTER 7 TROUBLESHOOTING
8/26/01, 3:49 PM
7-83