Sp1-Xxx: Feed - Ricoh B079 Service Manual

5.1.3 SERVICE TABLES

SP1-xxx: Feed

SP1 Mode Number
1001* Leading Edge Registration
1002* Side-to-Side Registration
1 Tray1
2 Tray2
3 Tray3
4 Tray4
5 Duplex Tray
6 By-pass Tray
7 LCT (if present)
1003* Registration Buckle Adjustment
1 Trays 2, 3, 4, LCT
2 Duplex Tray
3 By-pass Tray
4 Tray1 Feed
5 By-pass Thick Paper
1007 By-pass Feed Paper Size
Display
1012* Exit Junction Solenoid Start
Timing
1* Exit Entrance Junction
Solenoid
2* Exit Last Junction
Solenoid
1103* Fusing Idling
SM
CÓPIA NÃO CONTROLADA
Adjusts the printing leading edge registration using
the trimming area pattern (SP2-902-3, No.11).
[+9 ~ –9 / 3.0 / 0.1 mm]
Use  to toggle between ± before entering the
value.
Specification: 3 ±2 mm
Adjusts the printing side-to-side registration from
the 3rd paper feed station using the trimming area
pattern (SP2-902-3, No.11).
Use the  key to toggle between + and – before
entering the value.
Specification: 2 ±1.5 mm
[–9 ~ +9/ +3.0 mm / 0.1 mm step]
[–9~ +9/ +2.0 mm / 0.1 mm/step]
Tray3, Tray4 for Paper Feed Unit.
[–9 ~ +9/ +0.0 mm / 0.1 mm/step]
[–9 ~ +9/ +3.0 mm / 0.1 mm/step]
[–9 ~ +9/ +1.5 mm / 0.1 mm/step]
Adjusts the relay clutch timing at registration. Relay
clutch timing determines the amount of paper
buckle at registration. (A "+" setting causes more
buckling.)
[–9 ~+9/0/1 mm step]
[–9 ~+9/0/1 mm step]
[–9 ~+9/0/1 mm step]
[–9 ~+9/1/1 mm step]
[–9 ~+9/2/1 mm step]
Displays the paper width sensor data for the by-
pass feed table. (! 5.75)
Adjusts the timing of the solenoids at the entrance
and exit of the paper exit section to accommodate
the increased speed of the duplex unit.
This SP has been added to compensate for the
increased operation speed of the duplex unit for this
machine. Increase the value if the leading edges
are jamming. Decrease the value if trailing edges
are bending at the entrance.
B079:
[200 ~ 450 ms / 370 ms / 10 ms]
B082:
[200 ~ 450 ms / 300 ms (ent.) 370 ms (exit) /10 ms]
Switches fusing idling on/off. When on, printing will
not start until enough time has elapsed so the hot
roller can reach optimum temperature. This ensures
even heat on the hot roller.
Switch on if fusing on the 1st and 2nd copies is
incomplete (this may occur if the room is cold.)
5-5
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Function and [Setting]
B079/B082