Sp Mode Tables; Sp1-Xxx (Feed) - Ricoh Aficio 1013 Service Manual

5.1.1 SP MODE TABLES

NOTE: 1) An asterisk (*) after the SP number means that this SP's value is stored
in the SRAM. If you do a RAM reset, all these SP settings will be
returned to their factory defaults.
2) In the Function/[Setting] column:
• Comments are in italics.
• The setting range is enclosed in brackets, with the default setting
written in bold.
• DFU stands for Design/Factory Use only. Values marked DFU
should not be changed.
• IAJ means that you should refer to Section 3.13 ("Replacement and
Adjustment – Copy Image Adjustments") for more information. IP
means that you should refer to Section 6.7, (Detailed Descriptions –
Image Processing").

SP1-XXX (Feed)

1
Mode Number/Name
001* Leading Edge Registration
1 Paper tray (copy, fax)
2 Bypass (copy fax)
4 Paper tray (optional
printer)
5 Bypass (optional
printer)
002* Side-to-Side Registration
1 1st tray
2 2nd tray
5 Bypass
003* Paper Feed Timing
1 1st tray
2 Other trays
3 Bypass
106 Fusing Temperature Display
1
SM
USING SERVICE PROGRAM MODE
Function/[Setting]
Adjusts the plotter leading-edge registration from each
paper feed station. Use the Trimming Area Pattern (SP5-
902, No.10) to make the adjustment.)
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step] IAJ
• Specification: 0 ± 2 mm
• Use the ! key to select "+" or "–" when entering the
value.
Adjusts the printing side-to-side registration from each
paper feed station. (Use Trimming Area Pattern (SP5-902,
No.10) to make the adjustment.) The 2nd-tray adjustment
is for the optional tray.
[–9.0 ~ 9.0 / 0.0 / 0.1 mm/step] IAJ
• Specification: 0 ± 2 mm
• Use the ! key to select "+" or "–" when entering the
value.
Adjusts the amount of buckle the paper feed clutch
applies to the paper (by adjusting delay between
triggering of the registration sensor and activation of
registration clutch). A higher setting applies greater
buckling.
[0 ~ 10 / 5 / 1 mm/step]
Displays the fusing temperature.
Press ! to exit the display.
5-3 B044/B045/B046