Hot Roller Stripper Cleaning - Ricoh B079 Service Manual

IMAGE FUSING AND PAPER EXIT

6.15.8 HOT ROLLER STRIPPER CLEANING

After a job of more than the specified number of pages ends, the fusing/exit motor
switches off and on to rotate the hot roller in order to dislodge toner clinging to the
hot roller strippers.
When printing ends, the fusing/exit motor switches off for 15 sec. then switches on
for 15 sec. This on/off cycle is repeated for the number of times specified with
SP3905 1 (Default: 1 off/on cycle). While the fusing/exit motor is switched off/on
during the cleaning cycle, all fans remain on.
NOTE: The hot roller strippers can also be force cleaned by adjusting and raising
the setting of SP5959 (Image Timing Adjustment) which allows the drum
and hot roller to turn freely to allow more time for cleaning before printing.
However, make sure that the customer understands that increasing this SP
setting slows down the first print time.
These are the SP codes that control hot roller stripper cleaning. (For details, refer
to Section "5. Service Tables".
No.
SP3905 1 Number of Rotations
SP3905 2 Number of Pages
The timing chart below shows the fusing/exit motor switched off and on twice at the
end of a print job.
Print Job End
15 sec.
Fusing/
exit motor
Fusing
Temperature
B079/B082
CÓPIA NÃO CONTROLADA
Name
Prescribes the number of times the hot roller is
rotated at the end of the print job if the print job
exceeds the number of pages specified with SP3905
2. (Default: 1)
Prescribes the number of pages to print and trigger
hot roller stripper cleaning. Cleaning executes only if
the number of pages in the print job exceeds this
number. (Default: 15 pp.)
On/Off 2
Off/On 1
15 sec.
Re-load Temperature
CÓPIA NÃO CONTROLADA
Function
6-94
1 min.
B079D912.WMF
SM