Input Check; Main Machine Input Check: Sp - Ricoh B079 Service Manual

SERVICE PROGRAM MODE TABLES

5.1.5 INPUT CHECK

Main Machine Input Check: SP5-803

1. Enter the SP mode and select SP5-803.
2. Enter the number (1 – 13) for the item that you want to check. A small box will
be displayed on the SP mode screen with a series of 0's and 1's.
The meaning of the display is as follows.
0 0 0 0 0 0 0 0
Bit 7 6 5 4 3 2 1 0
3. Check the status of each item against the corresponding bit numbers listed in
the table below.
Number Bit
7 Fusing Exit Sensor
6 Near End Sensor 2
5 Near End Sensor 1
1: Paper Feed 4 Not Used
1 (Upper Tray)
3 Paper Size Sensor 4
2 Paper Size Sensor 3
1 Paper Size Sensor 2
0 Paper Size Sensor 1
7 Duplex Unit Set Sensor
6 Near End Sensor 2
5 Near End Sensor 1
4 Fusing/Paper Output Motor Lock Not Locked
2: Paper Feed
2 (Lower Tray)
3 Paper Size Sensor 4
2 Paper Size Sensor 3
1 Paper Size Sensor 2
0 Paper Size Sensor 1
7 Zero Cross Signal
6 Transfer Belt Unit HP Sensor
5 Exhaust Fan Lock Signal
4 Cooling Fan Lock Signal
3: Registration
and Others
3 Main Motor Lock Signal
2 Toner Overflow Sensor
1 Cover Open
0 Registration Sensor
B079/B082
CÓPIA NÃO CONTROLADA
Description
5-72
CÓPIA NÃO CONTROLADA
Reading
0
Activated Deactivated
Activated Deactivated
Activated Deactivated
--- ---
Activated Deactivated
Activated Deactivated
Activated Deactivated
Activated Deactivated
Unit set Unit not set
Off On
Off On
Locked
Activated Deactivated
Activated Deactivated
Activated Deactivated
Activated Deactivated
Detected Not detected
Not present Present
Not locked Locked
Not locked Locked
Not locked Locked
Tank not full Tank full
Cover closed Cover opened
Paper detected Paper not detected
1
SM