Ricoh B079 Service Manual page 272

SERVICE PROGRAM MODE TABLES
SP5 Mode Number
5812* 3* Supply
4* Operation
5816* 1 CSS Function On/Off
2 CE Call
5821* CSS PI Device Code
5824 NVRAM Data Upload
5825 NVRAM Data Download
5828* Network Setting
12 Device Name
66 Job Spooling Clear: Start
Time
5828* 69 Job Spooling (Protocol)
74* Delete Password
84* Print Settings List
B079/B082
CÓPIA NÃO CONTROLADA
Function and [Setting]
Use this to input the telephone number of your
supplier for consumables. Enter the number and
press #.
Press the
"Clear modes" key to delete the telephone
number.
Use this to input the service telephone. Enter the
number and press #.
Press the
"Clear modes" key to delete the telephone
number.
Japan Only
0: Off, 1: On.
Japan Only
0: Start, 1: Finish
Selects the PI device code. DFU
[0~4 / 0 / 1 step]
Uploads the UP and SP mode data (except for
counters and the serial number) from NVRAM on
the control board to a flash memory card.
While using this SP mode, always keep the front
cover open. This prevents a software module
accessing the NVRAM during the upload.
Downloads the content of a flash memory card to
the NVRAM on the control board.
Displays the device name used by the network in
the format RNPxxx... up to 48 characters.
This SP determines whether jobs spooled but not
printed when the machine was switched off are
printed the next time the machine is switched on.
[0~1 /1 /1]
0: Not printed at power on
1: Printed at power on
This SP is available only when job spooling is
enabled.
Switches job spooling off and on and allows
settings for job spooling protocols.
[0~1 / 1 / 1]
0: Off
1: On (All Active)
Protocols are enabled/disabled with bit switch
settings (0 = Off, 0 = On).
Bit0: LPR
Bit1: FPT
Bit2: IPP
Bit3: SMB
Bit4~Bit7: Reserved
Execute to delete network password.
Prints a list of all network related parameters.
5-46
CÓPIA NÃO CONTROLADA

key to input a pause. Press the

key to input a pause. Press the
SM