Ricoh B079 Service Manual page 688

IEEE 802.11B B515 (WIRELESS LAN)
UP Mode Settings for Wireless LAN
Enter the UP mode and follow the procedure below to perform the initial interface
settings for IEEE 802.11b. These settings take effect every time the machine is
powered on.
NOTE: The wireless LAN cannot be used if Ethernet is being used.
1. Press the User Tools/Counter key.
2. On the touch panel, press System Settings.
NOTE: The Network I/F (default: Ethernet) must be set for either Ethernet or
wireless LAN.
3. Select Interface Settings ! Network (tab) ! Network I/F Settting
4. Select either "Ethernet" or "IEEE 802.11b".
5. Press IEEE 802.11b. Only the wireless LAN options are displayed.
6. Transmission Mode. Select either "Ad Hoc Mode" or "Infrastructure Mode".
7. SSID Setting. Enter the SSID setting. (The setting is case sensitive.)
8. Channel. This setting is required when Ad Hoc Mode is selected.
Range: 1 ~ 14 (default: 11)
NOTE: The allowed range for the channel settings may vary for different
countries.
9. WEP (Privacy) Setting. The WEP (Wired Equivalent Privacy) setting is
designed to protect wireless data transmission. In order to unlock encoded
data, the same WEP key is required on the receiving side. There are 64 bit and
128 bit WEP keys.
Range of Allowed Settings:
64 bit 10 characters
128 bit 26 characters
10. Bandwidth Status. This setting is enabled only for the Infrastructure Mode.
Press here to display the current status of the bandwidth. One of the following
is displayed to reflect the reception status of the wireless LAN:
Good
Fair
Poor
Unavailable
B548
CÓPIA NÃO CONTROLADA
76 ~ 100%
41 ~ 75%
21 ~ 40%
0 ~ 20%
16
CÓPIA NÃO CONTROLADA
SM