Operation; General - Buderus Logamax plus GB162-80 kW Service Instructions Manual

4

Operation

4 Operation
section 11

General

General points
The heating boiler is fitted with a control panel, the BC10 basic
controller. The BC10 can be used to control the heating system.
In addition, it is possible to call up display readings, settings and
codes on the display of the BC10. The display settings can be
changed after calling them up. See chapter 5 "Symptoms" on
page 21.
section 12
 Briefly press the access cover of the BC10 to open it.
section 13
The control panel is located on the left, behind the access cover
[2].
The Operating Instructions are located in a compartment on the
back of the access cover [1].
10 Logamax plus GB162-80 kW/100 kW - Subject to modifications resulting from technical improvements!
section 14
The control panel has the following elements:
10 9
110
100 120
130
90
140
11 2
1
1
1: Main power switch
2: "Reset" button
3: "Chimney sweep" button
4: "Service" button
5: Service Tool Connector
6: LED "Burner operation"
7: LED "Central heat demand"
8: Space heating water temperature knob
9: Display
10: DHW temperature knob
11: LED "DHW demand"
Main power switch
The main power switch [1] is used to switch the mains power to
the heating boiler on and off.
"Reset" button
With certain faults you may have to restart the boiler by pressing
the "Reset" button [2]. This is only required in the event of a
"locking" fault (can be recognized by a flashing error code in the
display). During a reset, the display shows [\/r/e|.
Blocking errors (which can be recognized by a non-flashing
error code) are reset automatically as soon as their cause has
been removed.
"Chimney sweep" button
The "Chimney sweep" button [3] is used to activate a flue gas
test, the service mode or manual operation.
The flue gas test enables the boiler to be run in full-load oper-
ation manually for a short period. See also section 20, "Flue
Gas Test menu", page 13.
The service mode enables the boiler to be run in part-load
operation manually for a short period. The service mode should
be used to carry out measurements and settings on the boiler.
See also section 21, "Service Mode menu", page 14.
8
130
110
150
90
170
190
3 4 5
7
2 6