d d d d Lower Front Cover (Saddle Finisher-N2
Only)
Open this cover to replace the staple cartridge in
the saddle stitcher unit, or clear a staple or paper
jam in the saddle stitcher unit. (For instructions
on replacing the staple cartridge, see
"Replacing the Staple Cartridge in the Saddle
Stitcher Unit," on p. 7-24. For instructions on
clearing a staple jam, see "Saddle Stitcher Unit
(Optional)," on p. 8-70. For instructions on
clearing a paper jam, see "Saddle Stitcher Unit
(Optional)," on p. 8-57.
e e e e Booklet Tray (Saddle Finisher-N2 Only)
Prints that are saddle stitched are output to this
tray.
Finishing Modes
The Finisher-N1 and Saddle Finisher-N2 are equipped with the following finishing
modes.
CAUTION
•
Do not place anything other than output paper in the trays of the finisher, as
doing so may damage the trays.
•
Do not place anything under the trays of the finisher, as doing so may damage
the trays.
IMPORTANT
•
The following types of paper are output to the center output tray of the main unit and not
to the Output Tray of the finisher:
- 12 5/8" x 17 11/16" (320 mm x 450 mm) paper, envelopes, tracing paper,
transparencies, labels, tab paper, and Washi (Japanese paper).
•
Finishing modes cannot be set if you are using 12" x 18" (305 mm x 457 mm) or
12 5/8" x 17 11/16" (320 mm x 450 mm) paper.
f f f f Booklet Tray Guide (Saddle Finisher-N2
Only)
Set this guide to match the size of the output
paper. (See "Finishing Modes," on p. 3-23.)
g g g g Output Tray B
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for
outputting prints when using certain functions.
(See "Output Tray Designation," on p. 4-44.)
h h h h Output Tray A
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for
outputting prints when using certain functions.
(See "Output Tray Designation," on p. 4-44.)
Finisher-N1/Saddle Finisher-N2
3
3-23