Pop-Up Menus In Embroidery - Husqvarna Viking Designer I Usb User Manual

Pop-up menus in Embroidery

Embroidery Start Up Calibration
As the embroidery unit is connected to the mach-
ine, a Pop-up menu prompts you to slide off the
hoop, and clear the machine area for positioning
of the embroidery arm. Touch OK to calibrate
the embroidery unit and to position the arm.
This menu also reminds you to use the R foot.
Top Thread Break
USB
Your Designer I
thread runs out or breaks. Rethread the top th-
read, touch OK. Touch
Empty Bobbin
USB
Your Designer I
almost empty. Replace the empty bobbin with a
full one, touch OK (bobbin winding, see page
10).
Note: When changing the bobbin, touch
hoop will move away for easy access to the bobbin
case. Once the bobbin is replaced, touch
move the hoop back to where em broi dery stopped.
Touch to resume the embroidery.
Color Change
USB
Your Designer I
top thread only is cut at the color change. Re-
move the spool and rethread the top with the
recommended color shown in the color menu
of the color touch screen or in the Embroidery
Booklet. Touch OK and
dering.
Cut Embroidery Top Thread Tail
USB
Your Designer I
stitches after you begin embroidering. Cut the
star ting thread tail, touch OK and
embroidering.
Wrong hoop for embroidery
When the size of the hoop on the machine does
not match the size displayed on the screen, your
USB
Designer I
will not sew. Change the hoop to
the size displayed on the screen.
Stop requested in design
USB
Designer I
stops when you are supposed to
do a cut work, applique etc. See explanation for
each design in the Embroidery Booklet.
Embroidery fi nished
When your embroidery is complete a pop-up
menu will appear. Touch OK to get back to your
embroidery.
74
stops automatically if the top
to continue.
stops when the bobbin is
stops automatically and the
to resume embroi-
stops automatically a few
to resume
Embroidery
and the
again to