Connect The Power Cord And Foot Control; Pack Away After Sewing; Led Lights - Husqvarna Viking Jade 20 User Manual

Connect the Power Cord and Foot
Control
Among the accessories you will find the power cord and the
foot control.
Note: Consult a qualified electrician if you are in doubt about how to
connect the machine to the power source. Unplug the power cord when
the machine is not in use.
For this sewing machine, foot control model C-9002
manufactured by CHIEN HUNG TAIWAN Ltd must be
used.
1. Connect the foot control cord to the front socket on the
bottom right side of the machine (A).
2. Connect the power cord to the rear socket on the bottom
right side of the machine (B). Plug the cord into the wall
socket.
3. Press the ON/OFF switch to ON to turn on power and
light (C).
For the USA and Canada
This sewing machine has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way.

Pack Away After Sewing

1. Press the ON/OFF switch to "O".
2. Unplug the cord from the wall socket and then from the
machine.
3. Unplug the foot control cord from the machine. Wind
the cord around the foot control and place it inside the
storage box.
4. Place all accessories in the accessory tray. Slide the tray
on to the machine around the free arm.
5. Place the storage box on the machine and turn the
locking device to lock the box in place.

LED Lights

Your machine has LED lights which distribute the light
evenly over the sewing area and eliminate shadows.
2 Preparations 13