Org. Width Detect Adjust; Download Firmware - Konica Minolta bizhub 200 Service Manual

Field Service Ver. 2.5 Jul. 2006
10.7.9 FC
Functions • To check the Finisher operations.
Mode 1: Performs the move operation for the Stapling Unit.
Mode 2: Performs the move operation for the Aligning Plate.
Mode 3: Performs the ascent operation for the Elevator Tray.
Mode 4: Performs the descent operation for the Elevator Tray.
Mode 5
*1
Mode 6 *1
Mode 7: Performs the open/close operations for the Exit.
Use
Mode 8
*2
Mode 9 *2
Mode 10: Drives the transport section.
Mode 11: Performs the open/close operations for the Shutter.
Mode 12
Mode 13: Performs the single rotate operation for the Storage Paddle.
Mode 14: Performs the single rotate operation for the Exit Paddle.
1. From the Tech. Rep. Mode screen, touch [Function] → [FC] in that order.
Setting/
Procedure 2. Select an operation, and then press the Start key to begin the operation.
*1: appears only when the Punch Kit PU-5016 is installed.
*2: appears only when the Saddle Kit SD-502 is installed.
*3: appears only when the Mail Bin Kit MT-501 is installed.
10.7.10

Org. Width Detect Adjust

Functions
• To set the maximum and minimum sizes of the original for the ADF.
Use
Setting/ See P.18 of the DF-605 service manual.
Procedure
10.7.11

Download Firmware

2
Functions
• To upgrade the firmware of the engine or Finisher.
Use
Setting/ See P.43 of the main unit service manual.
See P.7 of the FS-508/PU-501/OT-601 service manual.
Procedure
: Performs the Punch drive operation.
: Performs the Punch drive operation. (2 holes)
: Performs the drive operation for the Creasing Unit.
: Performs the open/close operations for the Saddle Exit.
*3 : Drives the Mail Bin Solenoid.
10. Tech. Rep. Mode
169