Base Assembly; Removing The Base Assembly (1) - Toshiba PORTEGE R830 Maintenance Manual

4.8 Base assembly

4.8 Base assembly
Removing the Base assembly
To remove the base assembly, follow the steps below and refer to Figure 4-11 to 4-14.
1. Take out the tab under the base assembly.
2. Lift up the flip of the connector and disconnect the ExpressCard FPC from the
connector CN2520 on the system board while holding the tab.
ExpressCard FPC
PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880)
Tab
Figure 4-11 Removing the base assembly (1)
4 Replacement Procedures
Flip
CN2520
[CONFIDENTIAL] 4-23