4.12 Cover assembly and Base assembly
4.12 Cover assembly and Base assembly
Removing the cover assembly and base assembly
The following describes the procedure for removing the cover assembly and base assembly.
(See Figure 4-18 to 4-20.)
1. Turn the display 90 degrees clockwise and remove the hinge rear cover.
2. Remove the following screws. Be careful not to forget removing these screws.
• M2.5×6B
3. Remove the following screw.
• M2.5×8B
Hinge rear cover
M2.5×8B FLAT HEAD
Figure 4-18 Removing the cover assembly and base assembly (1)
Satellite R20/TECRA M7 Maintenance Manual (960-572)
FLAT HEAD screw
FLAT HEAD screw
M2.5×6B FLAT HEAD
4 Replacement Procedures
×2
×1
[CONFIDENTIAL]
4-31