Cover Assembly And Base Assembly; Removing The Cover Assembly And Base Assembly - Toshiba TECRA A9 Series Maintenance Manual

4 Replacement Procedures
4 Replacement Procedu es r

4.13 Cover assembly and Base assembly

Removing the Cover assembly and Base assembly

To remove the cover assembly and base assembly, follow the steps below and refer to Figure
4-21 and 4-22.
1. Close the display and turn over the computer.
2. Remove the following screws.
•
M2.5×6B
•
M2.5×16B
3. Disconnect the USB cable from the connector CN4612 on the system board.
"16"
"16"
"6"
USB cable
(Connected to CN4612)
Figure 4-21 Removing the cover assembly and base assembly (1)
4-36 [CONFIDENTIAL] TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633)
FLAT HEAD screw
FLAT HEAD screw
"6"
"6"
"16"
"6"
4.13 Cover assembly and Base assembly
×8 ("6" in the figure below)
×5 ("16" in the figure below)
"16"
"16"
"6"
"6"
"6"
"6"