4.19 Sound board
4.19 Sound board
Removing the Sound board
To remove the sound board, follow the steps below and refer to Figure 4-38 to 4-41.
1. Remove the following screw and speaker holder R.
• M2×4C
2. Peel off the aluminum tape and disconnect the speaker harness from the connector
CN6000 on the sound board.
3. Disconnect the camera harness, sensor harness and inner harness from the
connector CN9540, CN9620 and CN6050 on the sound board.
M2x4C S-THIN HEAD
Camera harness
(Connected to CN9540)
Sensor harness
(Connected to CN9620)
PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880)
S-THIN HEAD
Speaker holder R
Figure 4-38 Removing the sound board (1)
4 Replacement Procedures
×1
Aluminum tape
Speaker harness
(Connected to CN6000)
Sound board
Inner harness
(Connected to CN6050)
[CONFIDENTIAL]
Conductive cloth
4-63