Toshiba PORTEGE R830 Maintenance Manual page 376

4 Replacement Procedures
Installing the Cover assembly/LCD assembly
To install the cover assembly/LCD assembly, follow the steps below and refer to Figure 4-49
and 4-50.
1. Set the PW SW button to the cover assembly while engaging the latch.
2. Connect the sensor harness to the sensor board.
3. Set the sensor board to the appli button.
4. Set the appli button to the cover assembly while engaging the latch.
5. Set the LCD assembly to the cover assembly and secure them with following screw.
• M2.5×4B
6. Turn up the insulator and arrange the harnesses.
NOTE: When arranging harnesses of the left side, refer to the following figure.
4-82 [CONFIDENTIAL]
FLAT HEAD
PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880)
4.24 Cover assembly/LCD assembly
×1