Sd Card Slot Troubleshooting; Procedure 1 Check On Windows Os; Procedure 2 Connector Check And Replacement Check - Toshiba PORTEGE R830 Maintenance Manual

Troubleshooting Procedures

2.15 SD Card Slot Troubleshooting

This section describes how to determine if the computer's SD Card functions are functioning
properly. Perform the steps below starting with Procedure 1 and continuing with the other
procedures as required.
Procedure 1: Check on Windows OS
Procedure 2: Connector Check and Replacement Check

2.15.1 Procedure 1 Check on Windows OS

Insert a SD Card (SD memory card/Multimedia card) into the slot. Check if the installed
Windows recognizes automatically the SD Card and the data in the SD Card can be read.
If the card is not recognized or data are not red, go to Procedure 2.

2.15.2 Procedure 2 Connector Check and Replacement Check

The SD Card is connected to IS2130 on the SD/SATA ODD board (FAL3SA*).
SD Card supports SD memory card/Multimedia card.
As the connection may be defective, disassemble the computer and check each connection.
If the problem still occurs, go to Check 1.
Check 1 SD Card may be disconnected. Make sure the SD Card is firmly inserted to IS2130.
If not, insert it firmly. If the SD Card is still not functioning properly, perform
Check 2.
Check 2 SD Card may be faulty. Replace it with a new one following the step in Chapter 4
Replacement Procedures. If the problem continues, perform Check 3.
Check 3 SD/SATA ODD board (FAL3SA*) or the FPC (FAL3YA*) may be damaged.
Replace it with a new one following the instructions in Chapter 4, Replacement
Procedures. If the problem still exists, perform Check 4
2-54
PORTEGE R830 Satellite R830 Series Maintenance Manual (960-880) [CONFIDENTIAL]