Table of Contents
Advertisement
Operating Instructions
SYMPTOM
Unsatisfactory adhesion of
laminate.
Waves in my output
POSSIBLE CAUSE
Speed setting too fast for type of
material being laminated.
Insufficient heat.
Laminate improperly loaded.
Heat rollers require cleaning.
Laminated item unsuitable for adhesion.
See sub section Output.
Nips may be out of calibration.
62FM L
CORRECTIVE ACTION
Lower speed setting by pressing Slow
button to slower speed
Wait for READY indicator to appear in
the control panel display.
Adhesive side of film must be facing
away from the heat rollers.
Bottom roll of film not threaded behind
the idle bar.
Clean heat rollers per procedure in
section Maintaining the 62FM Laminator.
Item may be dirty or may have
nonporous surface that is extremely
difficult to laminate.
Under section titled Lamination Guide.
Place a service call for calibration check.
AMINATOR
7-3
Advertisement
Table of Contents
