Polycom VSX 7000 Administrator's Manual page 116

VSX 7000 Series Administrator's Guide
Appendix - 10
Code Cause
65 Bearer capability not
implemented
66 Channel type not
implemented
69 Requested facility
not implemented
70 Only restricted digital
information bearer is
available
79 Service or option not
available,
unspecified
81 Invalid call reference
value
82 Identified channel
does not exist
83 A suspended call
exists but this call
identity does not
84 Call identity in use
85 No call suspended
86 Call having
requested call
identity has been
cleared
88 Incompatible
destination
91 Invalid transit
network specified
95 Invalid message,
unspecified
96 Mandatory
information element
is missing
Definition
The network is not capable of providing the bearer
capability requested by the user.
The requested channel type is not supported by the
equipment sending this code.
The remote equipment is not capable of providing the
requested supplementary service.
The network is unable to provide unrestricted digital
information over bearer capability.
The network or remote equipment is unable to provided
the requested service option for an unspecified reason.
This might be a subscription problem.
The remote equipment received a call with a call
reference that is not currently in use on the
user-network interface.
The receiving equipment is requested to use a channel
that is not activated on the interface for calls.
The network received a call resume request that
contained a call identity information element that does
not match any suspended call.
The network received a call suspend request that
contained a call identity information element for a call
that is already suspended.
The network received a call resume request when there
was not a suspended call pending. This might be a
transient error that will be resolved by successive call
retries.
The network received a call resume request containing
a call identity information element for a call that was
cleared while suspended, either by timeout or by the
remote user.
Indicates that an attempt was made to connect to
non-ISDN equipment, such as an analog line.
The ISDN exchange was asked to route the call through
an unrecognized intermediate network.
An invalid message was received, for an unknown
reason. This is usually due to a D-channel error. If this
error occurs systematically, report it to your ISDN
service provider.
The equipment received a message that did not include
one of the mandatory information elements. This is
usually due to a D-channel error. If this error occurs
systematically, report it to your ISDN service provider.
www.polycom.com/videodocumentation