Sdk; Before You Use The Terminal; Install And Charge Battery Pack; Configure The Terminal - Symbol PDT 7200 series Reference Manual

®
PDT 7200 Series Product Reference Guide for Windows CE
Spectrum24 Radio Terminals
Spectrum24 terminals are equipped with a Spectrum24 adapter card (Type II PC card
connected to an internally mounted antenna) that enables the terminal to operate in a
Spectrum24 network.
The software required (interface, drivers, and configuration files) is described in the Windows
CE SDK Help File. For information on configuration file edits to ensure proper operation of
the terminal in a Spectrum24 environment, refer to the Spectrum24 NDK.

SDK

The PDT 7200 Series Software Development Kit (SDK) contains software and online
documentation to assist you in developing applications to run on the PDT 7200.
You will need one or more application development environments (ADEs) from other
vendors to develop applications for the PDT 7200, for example Microsoft Visual C++.

Before You Use the Terminal

Install and Charge Battery Pack

Prior to using the PDT 7200 for the first time, charge the Lithium-Ion battery pack. The
battery pack can be charged while in the terminal or charged separately in the cradle's
charging slot. See Chapter 4, Cradle Setup and Operation, for instructions on installing the
cradle(s) and installing and charging the battery pack.

Configure the Terminal

Terminal configuration consists of loading the software and applications onto the terminal
and setting the terminal's operating parameters. For more information on configuration refer
to Chapter 6, Configuring the Terminal.

Starting the PDT 7200

After installing and charging the battery, start the terminal by pressing the icon on the
screen. If the terminal does not power on, perform a hard reset. See Booting the Terminal on
page 5-3 for instructions.
As the terminal initializes its unique Flash File system, the Symbol splash screen displays for
about a minute.
1-6