Peripheral Configuration Submenu - Fujitsu PRIMERGY TX300 S4 User Manual

Chapter 7 Configuring Hardware and Utilities

7.2.6 Peripheral Configuration Submenu

This submenu appears when you select [Peripheral Configuration] from the [Advanced] menu.
It is for setting the serial port, parallel port, etc.
Use a scroll bar to display the hidden areas of the screen.
Main Advanced
Serial 1:
Serial Multiplexer:
Serial 2:
Parallel:
USB Host Controller:
USB 2.0 Host Controller:
USB BIOS Supported Devices:
USB Boot Delay:
USB BIOS Hot-Plug:
USB Front
USB Rear
ATA Controller Config
>
F1
Esc Exit
Item
Serial 1
Serial 1 Address
Serial Multiplexer
Serial 2
Serial 2 Address
Parallel
Parallel Mode
Parallel Address
200
PhoenixBIOS Setup Utility
Security Server
Peripheral Configuration
[Auto]
[System]
[Auto]
[Disabled]
[Enabled]
[Enabled]
[Auto]
[0 s]
[Enabled]
[Enabled]
[Enabled]
-/+ Change Values
Select Item
Select Menu Enter Select > Sub-Menu
table: Peripheral Configuration submenu
Setting
• Disabled
• Enabled
• Auto (Initial value)
• OS Controlled
3F8h (Unchangeable)
• System (Initial value)
• iRMC
• Disabled
• Enabled
• Auto (Initial value)
• OS Controlled
2F8h, IRQ 3 (Unchangeable)
• Disabled (Initial value)
• Enabled
• Auto
• Bidirection (Unchangeable)
• 378h, IRQ7 (Unchangeable)
Exit
Item Specific Help
Configure serial port
using options
[Disable]
No configuration
[Enabled]
User configuration
[Auto]
BIOS or OS chooses
configuration
F9 Setup Defaults
Description
Sets whether to enable or disable the serial port. Set
this item to "Disabled" when you use it as a server
management port.
Note:
When [Serial Multiplexer] is changed to
"iRMC", set this item to "Disabled".
Appears when [Serial 1] is "Enabled".
Switches the function of serial port 1 as below:
• System
Uses this port as a serial port (setting where UPS
is used).
• iRMC
Uses this port as a server management port. Set
[Serial 1] to "Disabled".
Sets whether to enable or disable the serial port.
Appears when [Serial 2] is "Enabled".
Sets whether to enable or disable the parallel port.
Sets the data transfer mode of the parallel port.
Appears when [Parallel] is "Enable" or "Auto".
Appears when [Parallel] is "Enabled".