Fujitsu PRIMERGY TX300 S4 User Manual page 183

3. Connect the SCSI cable to the SCSI card (PG-2281).
Pass the cable as shown in the figure below.
For LTO4 unit
1. Install a SAS card (PG-224B).
For how to install expansion cards, refer to "6.5.3 How to Install Expansion Cards"
( pg.164).
2. Connect the power cable and the SAS cable to the internal device.
Rear of LTO4 unit
Power connector
3. Connect the SAS cable to the SAS card (PG-224B).
Pass the cable in the same manner as the SCSI type.
9
Attach the front and side covers.
SAS connector
PRIMERGY TX300 S4 User's Guide
183