Console Redirection Submenu - Fujitsu PRIMERGY TX300 S4 User Manual

7.2.17 Console Redirection Submenu

This submenu appears when you select [Console Redirection] from the [Server] menu.
It is for detailed settings of console redirection that uses a serial port.
Main Advanced
Console Redirection:
F1 Select Item
Esc Exit Select Menu
Item
Console Redirection
Port
Baud Rate
Protocol
Flow Control
Mode
PhoenixBIOS Setup Utility
Security Server Exit
Console Redirection
[Disabled]
-/+ Change Values
Enter Select > Sub-Menu
table: Console Redirection submenu
Setting
• Disabled (Initial value)
• Enabled
• Serial 1 (Initial value)
• Serial 2
• 1200
• 2400
• 4800
• 9600 (Initial value)
• 19.2K
• 38.4K
• 57.6K
• 115.2K
• VT100
• VT100, 8bit
• PC-ANSI, 7bit
• PC-ANSI
• VT100+ (Initial value)
• None
• XON/XOFF
• CTS/RTS (Initial value)
• Standard
• Enhanced (Initial value)
PRIMERGY TX300 S4 User's Guide
Item Specific Help
F9 Setup Defaults
Description
Sets whether to enable console redirection. When
"Enabled" is set, the following items appear. Set each
item.
Sets the serial port used for console redirection.
When console redirection is used, use this item to set
the baud rate to be used for console redirection.
When console redirection is used, use this item to set
the console type for console redirection.
Sets the flow control.
Sets the scope of use for console redirection.
215