Security; Hardware Security - Fujitsu PRIMERGY TX300 S4 User Manual

Chapter 8 Operation and Maintenance

8.4 Security

This server provides security provisions in order to protect resources of both
hardware and software against theft and such. Additional security functions, such as
preventing unauthorized use, provided by BIOS Setup Utility are also available to
help maintain a highly reliable data security system.

8.4.1 Hardware Security

This section describes security function of hardware.
Locking the drive cover
Lock the drive cover to protect the hardware (hard disk units and 5-inch internal options) in the server
from theft or tampering.
Turn the key clockwise to lock the cover.
The drive cover shall be locked on the upper part of the server while the server is running in a manner
that the lock point is about 25 mm away from the top edge of the server to the drive cover. If not
adequate, the cover may not be locked. Check the cover is properly locked anytime.
Do not lose the drive cover key. If the key is lost, contact an office listed in the "Contact Information" of
"Start Guide".
For how to open the drive cover, refer to "1.4.1 Sliding the Drive Cover" ( pg.31).
238