Peripheral Configuration; Usb Configuration - Fujitsu PRIMERGY BX620 S4 Operating Manual

BIOS Setup
PCI Configuration
Calls a submenu for setting up the PCI slots and PCI components on the
system board (see
CPU Configuration
Calls a submenu for defining the CPU settings.
6.4.1

Peripheral Configuration

The Peripheral Configuration submenu contains the following items:
Serial 1
This field allows you to set up the serial port SER1.
Serial Port 1 Address
Defines the basic I/O address and the interrupt of the serial interface
(3F8h/IRQ4, 2F8h/IRQ3, 3E8h/IRQ4, 2E8h/IRQ3).

USB Configuration

Calls a submenu for defining the USB settings.
6.4.1.1 USB Configuration
The USB Configuration submenu contains the following items:
USB Devices Enabled
Indicates the number of the connected USB devices. If no USB device is
connected, this field shows None.
USB Functions
Defines whether the USB hardware is switched on (4 USB Ports) or off
(Disabled). If this menu item shows Disabled, the USB controller is not
recognized by an operating system and you cannot operate any USB
devices.
USB 2.0 Controller
Defines whether the USB (Universal Serial Bus) controller of the system
board is operated according to specification 2.0 (Enabled) or according to
specification 1.1 (Disabled). If this menu item is set to Enabled, the system
BIOS defines the system resources to be used (interrupts, addresses).
Legacy USB Support
Defines whether the USB keyboard and mouse emulation is Enabled or
Disabled. When the Auto setting is selected, the USB emulation is
enabled automatically when USB devices are connected.
BX620 S4
section "PCI Configuration" on page
Operating Manual
Advanced Menu
52).
51