Konica Minolta magicolor 2400W Service Manual page 118

Field Service Ver. 4.0 Feb. 2006
H. ENERGY SAVER
NOTE
• This menu is displayed only on 110V models.
Function • Selects whether to use Energy Saver or not.
Use • To enable or disable Energy Saver.
Setting • The default setting is ON.
/procedure
I. RESTORE USER DEFAULT
Function • Resets the ENERGY SAVER, AUTO CONTINUE, TRAY CHAINING, DUPLEX
DENSITY, ALTITUDE SETUP and TRANSFER VOLTAGE values to their factory
default settings.
• Resets the administrator password to its factory default setting.
Use • To reset the ENERGY SAVER, AUTO CONTINUE, TRAY CHAINING, DUPLEX DEN-
SITY, ALTITUDE SETUP, and TRANSFER VOLTAGE menus and administrator pass-
word to their factory default settings.
Setting 1. Select RESTORE USER DEFAULT and press the Menu Select key.
/procedure 2. This initializes the setting values of the functions involved are reset to their factory
default values, and the Engine/Service menu reappears.
J. DUPLEX DENSITY
Function • Adjusts the T/C ratio control level when a faulty image density occurs due to changes
in weather or environment.
Use • To adjust the T/C ratio changes to compensate for changes in the user's operating
environment during 2-sided printing.
Setting • The default setting is 0.
/procedure 1. With RESTORE USER DEFAULT selected, hold down the
more.
2. With DUPLEX DENSITY selected, press the < or > key as necessary to select the
appropriate density level value.
3. Press the Menu/Select key to accept the new density level setting.
"ON"
Adjustment range: -3 to +3
10. Menu (magicolor 2430 DL)
OFF
key for 2 seconds or
83