Fujitsu fi-6000NS Operator's Manual page 335

Code
12010001 Scanned data size exceeded
maximum size allowed for
e-mail attachments.
12010002 Could not connect to server
when sending e-mail.
12010003 "From" address was rejected by
the server when sending e-mail.
12010004 "To" address was rejected by
the server when sending e-mail.
12010005 e-Mail size exceeded maximum
e-mail size allowed by the
SMTP server.
Message
Try the following:
• Reduce the number of pages to be
• Select a higher compression level and
If the problem persists, contact a system
administrator to check the "Maximum
Attachment Size" setting.
"3.6.6 Setting the e-Mail Server (SMTP
Server)" (page 69)
Try the following:
• Check that the LAN cable of the scanner
• Contact a system administrator to check
• Contact a system administrator to check
Contact a system administrator to check
that the specified e-mail source address is
authorized for use on the server.
Contact a system administrator to check
that the specified e-mail destination
address is authorized for use on the server.
Contact a system administrator to check
the maximum e-mail size allowed by the
SMTP server.
Network Scanner fi-6000NS Operator's Guide
Action
scanned and send the e-mail in separate
parts.
try again.
"4.7.8 Compression" (page 188)
and SMTP server is connected properly.
that then scanner IP address and SMTP
server settings are correct.
"6.3 Network Connection
Troubleshooting" (page 234)
that the SMTP server is working
properly.
C
309