Fujitsu fi-6000NS Operator's Manual page 319

Screen
Scanning Feed Error: Document(s) may not
match the set paper size, ADF may
have grabbed more than one sheet, or
documents may not be suitable for
scanning. Remove the documents
from the ADF, check them and try
again. If problem persists, consult the
manual.
Insufficient memory. Try turning the
power off and back on again. If
problem persists, the administrator
should contact the FUJITSU scanner
dealer or an authorized FUJITSU
scanner service provider for help.
An error has occurred. Some pages
were skipped. Try again after turning
the power off and back on again. If
problem persists, the administrator
should contact the FUJITSU scanner
dealer or an authorized FUJITSU
scanner service provider for help.
Number of Skipped Pages:
Scanner hardware failure. The
administrator should contact the
FUJITSU scanner dealer or an
authorized FUJITSU scanner service
provider for help.
Message
Network Scanner fi-6000NS Operator's Guide
Action
Press the ADF release button to
open the top cover, and remove the
documents from the ADF. If more
than one sheet has been fed, reset
the document and try again.
Check that the actual document(s)
size matches the paper size
specified in the "Paper Size"
screen. If not, specify the paper
size again.
For details, refer to "4.7.3 Paper
Size" (page 175).
Try the following:
• Reduce the size of the scan data
or set a lower resolution level,
and try again.
• System might be unstable. Try
turning the power off for ten
seconds, and back on again. If
the error status persists, contact
your FUJITSU scanner dealer
or an authorized FUJITSU
scanner service provider.
Try turning the power off for ten
seconds, and back on again. If the
problem persists, contact your
FUJITSU scanner dealer or an
authorized FUJITSU scanner
service provider.
Try turning the power off for ten
seconds, and back on again. If the
problem persists, contact your
FUJITSU scanner dealer or an
authorized FUJITSU scanner
service provider.
C
293