Parameter Clear, All Parameter Clear - Mitsubishi Electric F700 Instruction Manual

Parameter clear, all parameter clear

4.7 Parameter clear, all parameter clear
POINT
· Set "1" in Pr. CL parameter clear, ALLC All parameter clear to initialize parameters. (Parameters are not cleared
when "1" is set in Pr. 77 Parameter write selection.)
· Refer to the parameter list on page 78 for parameters to be cleared with this operation.
Operation
1.
Screen at powering on
The monitor display appears.
2.
Press to choose the PU operation
mode.
3.
Press to choose the parameter
setting mode.
4.
Turn until "
appears.
5.
Press to read the currently set value.
" "(initial value) appears.
6.
Turn to change it to
the setting value " ".
7.
Press to set.
and
The inverter is not in the PU operation mode.
1. Press
2. Carry out operation from step 6 again.
72
", " "
· Turn to read another parameter.
· Press to show the setting again.
· Press twice to show the next parameter.
are displayed alternately ... Why?
.
is lit and the monitor (4 digit LED) displays "0" (Pr. 79 = "0" (initial value)).
Display
PU indication is lit.
Parameter clear All parameter clear
Parameter clear
Flicker ··· Parameter setting complete!!
The parameter
number read
previously appears.
All parameter clear