Parameter Verification - Mitsubishi Electric F700 Instruction Manual

Parameter copy and parameter verification
appears...Why?
appears...Why?
and
Appears when parameters are copied between the inverter of
1. Set "0" in Pr. 160 User group read selection.
2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.
Pr. 989 Setting
3. Reset Pr. 9, Pr. 30, Pr. 51, Pr. 52, Pr. 54, Pr. 56, Pr. 57, Pr. 70, Pr. 72, Pr. 80, Pr. 90, Pr. 158, Pr. 190 to Pr. 196, Pr. 557,
Pr. 893.
4.8.2

Parameter verification

Whether same parameter values are set in other inverters or not can be checked.
1.
Move the operation panel to the
inverter to be verified.
• Move it during a stop.
2.
Screen at powering on
The monitor display appears.
3.
Press to choose the parameter
setting mode.
4.
Turn until
appears.
5.
Press
value.
" "(initial value) appears.
6.
Turn to change it to the set value
" "(parameter copy verification mode).
7.
Press
of the verified inverter to the operation panel.
• If different parameters exist, different
parameter numbers and
• Hold down
8.
If there is no difference,
flicker to complete verification.
REMARKS
When the copy destination inverter is not the FR-F700 series, "model error (
flickers ... Why?
Set frequencies, etc. may be different. Check set frequencies.
74
Parameter read error. Perform operation from step 3 again.
Parameter write error. Perform operation from step 8 again.
flicker alternately
55K or less
10
Operation
(parameter copy)
to read the present set
to read the parameter setting
flicker.
to verify.
and
55K
or less and
Display
Flicker ··· Parameter verification complete!!
)" is displayed.
75K
or more.
75K or more
100
The parameter
number read
previously appears.
The frequency flickers
for about 30s
Flickering