Start/stop from the operation panel (PU
operation mode)
10.
Deceleration
Turn the potentiometer (frequency setting
potentiometer) counterclockwise slowly to full.
The frequency on the indication decreases
by the Pr. 8 Deceleration time, and the motor stops
rotating with "
indication.
[FWD] indication or [REV] indication flickers.
11.
Stop
Press
.
[FWD] indication or [REV] indication turns OFF.
Change the frequency (60Hz) of the maximum value of potentiometer (at 5V)
Adjust the frequency in Pr. 125 Terminal 2 frequency setting gain frequency. (Refer to page 62.)
Change the frequency (0Hz) of the minimum value of potentiometer (at 0V)
Adjust the frequency in calibration parameter C2 Terminal 2 frequency setting bias frequency. (Refer to the
chapter 4 of
54
Operation
" (0.00Hz) displayed on the
the Instruction Manual (applied).)
Display
Flickering
Stop