Utility mode
To specify a software switch setting
1
Display the Administrator Management 2 screen, and then touch [Initial
Settings].
–
For details on displaying the Administrator Management 2 screen,
refer to "Displaying the Administrator Management screen" on
page 11-24.
The Initial Settings screen appears.
2
Touch [Software SW].
3
Touch [Mode Selection], and then
use the keypad to type in the mode
number.
4
Touch either [Bit Selection] or [HEX
Selection], and then specify the set-
ting.
–
To specify the bits, touch [Bit Se-
lection] , touch
move the cursor to the bit to be
changed, press either the [0] or
[1] key in the keypad to specify
the bit, and then touch [Enter].
250/350
and
to
11
11-51