4
4.2
Printing a sample to check the settings (Proof Copy)
Before printing a large number of copies, a single proof copy can be printed
to be checked. This prevents copy errors from occurring.
To make test prints
1
Position the document to be copied. (Refer to page 3-8 for details.)
2
Select the desired copy settings.
3
Press the [Proof Copy] key.
A single proof copy is printed.
4
Check the proof copy.
–
If the proof copy was printed as desired, skip to step 8.
–
To change the copy settings, continue with step 5.
5
Touch [Change Setting] in the screen
that appeared when the proof copy
was printed.
6
In the Proof copy screen, change the
copy settings as desired.
–
The Finishing settings appear in
the Proof copy screen only if they
have been specified for the job
being proofed. If the copy set-
tings cannot be changed, stop
printing the proof copy. Next,
press the [Reset] key to cancel
the copy settings, and then specify the desired settings.
4-6
Additional copy operations
250/350