Removal Of The Bottom Housing Cover - SATO CG412DT Service Manual

7.3 REMOVAL OF THE BOTTOM HOUSING COVER

1.
Make sure the printer is powered off and disconnect the
power cable and interface cable.
2.
From the base of the printer, remove three screws (circled)
as shown.
CAUTION:
Ensure not to scrape the window portion when the printer
is turned over.
3.
Remove the Bottom Housing cover .
Proceed the necessary procedures to perform your desired
task on Installation, Adjustment or Replacement.
4.
Follow the above steps in reverse sequence to reassemble
the Bottom Housing cover .
Notes:
• Ensure the wiring route neatly as shown and arrange all
the wiring to avoid from being pinched when fitting the
bottom housing cover .
• When reassemble the Bottom Housing cover to the
printer with IEEE interface terminal , flip one of the clip
of the interface terminal as shown. Then fix the Bottom
Housing cover while holding the other clip , pulling the
Bottom Housing cover forward and downward.
CG4 Series Service Manual
Section 7: Replacement Procedures
screw x 3
clip
Page 7-5