SATO CG412DT Service Manual page 52

Section 4: Operation and Configuration
OPERATION SETTING MODE
4.5
Procedures
3
Press the FEED/LINE
button repeatedly to
select different operation
setting mode cyclically.
* Keypad and
Scanner/ Smart
keyboard selection is
only available for USB
and RS-232C board
printer. If this selection
is selected, even if the
device is not
connected, other
interfaces cannot be
activated.
4
When the desired mode
is selected, press the
FEED/LINE button for
more than 3 seconds
until both the ON LINE
(POWER) and ERROR
indicator is turned off.
5
Press the POWER button
to turn off the printer,
then press again to turn it
on.
(NOTE: This step is NOT
required for download mode.)
Page 4-14
(cont'd)
Printer status
Program Download
Mode
FEED/LINE
Font Download Mode
FEED/LINE
Default setting Mode
FEED/LINE
HEX Dump Mode
FEED/LINE
USB interface
FEED/LINE
RS-232C/ LAN/
IEEE1284 interface
FEED/LINE
Keypad is selected*
FEED/LINE
Scanner/ Smart
keyboard is selected*
FEED/LINE
Confirmation of the
selected mode.
(while pressing FEED/LINE)
Completion of function
execution.
(after release of FEED/LINE)
The selected mode will
be valid by restarting
the printer.
(For download mode selection, the printer will continue to complete the
downloading process. Refer to section 4.6 and 4.7 for details.)
ON LINE (POWER)
indicator
Blinking green light Off
Red light
Off
Blinking red light
Off
Blinking green light Blinking red light
Blinking red light
Blinking green light
Blinking green light Off
(longest blink interval)
Blinking red light
Off
(longest blink interval)
Blinking red light
Blinking green light
(longest blink interval)
(longest blink interval)
Off Off
Green light Off
(except for download mode, in which case
the ERROR indicator will be lighted in red
instead.).
CG4 Series Service Manual
ERROR
Buzzer
indicator
Three
short
beeps
One short
beep
Three
short
beeps