Linerless (Non Sepa) Label Sensor Replacement (Optional) - SATO CG412DT Service Manual

7.15 LINERLESS (NON SEPA) LABEL SENSOR REPLACEMENT (OPTIONAL)

This section covers the basic mechanical procedures for replacement of the Linerless (Non sepa) label
sensor.
1.
Remove the Bottom Housing Cover as explained in the
earlier Section 7.3 Removal of the Bottom Housing
cover .
2.
Disconnect the Linerless (Non sepa) label sensor cable
from the OPTION connector on the MAIN PCB .
3.
Turn over the printer in upright position, open the Top cover
and remove the Linerless (Non sepa) assembly by
pushing it upward.
4.
From the reverse side of the Linerless (Non sepa) assem-
bly , remove the screw securing the Linerless (Non sepa)
label sensor holder in place.
5.
Press the tabs to release the Linerless (Non sepa) label
sensor and remove the cable attached to the connector
6.
Replace the new Linerless (Non sepa) label sensor and
follow the above steps in reverse sequence, to reassemble
the parts.
CAUTION:
Ensure that no cables are pinched between parts when
you are installing the cutter kit to the printer.
7.
After replacement, perform Tear off offset position adjust-
ment. Refer to Section 6.6 Offset position Adjustment .
CG4 Series Service Manual
Section 7: Replacement Procedures
MAIN PCB
OPTION
connector
Linerless (Non sepa)
label sensor
tabs
Sensor holder
screw
connector
Page 7-21