Section 3: Interface Specifications
3.5 LOCAL AREA NETWORK (LAN) ETHERNET (cont'd)
Communication
configuration
Maximum receive
buffer capacity
3.5.2 Software Specifications
Protocol
Network layer
Session layer
Application layer
Notes
•
Send the print data by LPR and FTP of TCP/IP and dedicated socket protocol. (STATUS3, Protocol for
driver (STATUS4))
•
Use socket connection to get the printer status.
Page 3-16
The following settings can be configured via the Printer configuration tool or com-
mands.
Item
LAN mode
IP address
Subnet mask
Gateway address
IP address setup
RARP
1
2-port connection by Port1024 and Port1025 or 1 port connection by
*
Port9100.
2
1 port connection by Port1024 or Port9100.
*
Note :
Please refer to the Command specification for more details in Sending com-
mands.
1MB
0MB
Buffer near full
occurred
Buffer near full
released
TCP/IP
ARP, RARP, IP, ICMP
TCP, UDP
LPR, FTP, TELNET, BOOTP, DHCP, HTTP
Command
<I3>
Protocol for driver (STATUS4) cyclic
response mode *
Protocol for driver (STATUS4) ENQ
response mode *
STATUS3 *
[Coding example]
To set the protocol for driver (STATUS4) cyclic response
mode, send the following command to printer:
<A>
<I3>0
<Z>
<W1>
0.0.0.0 ~ 255.255.255.255
<W2>
0.0.0.0 ~ 255.255.255.255
<W3>
0.0.0.0 ~ 255.255.255.255
<WI>
Manual
DHCP
<WM>
RARP disabled
RARP enabled
Setting range
1
1
2
Remaining 0.25MB
Remaining 0.5MB
CG4 Series Service Manual
1MB