Optional Accessories Specifications - SATO CG412DT Service Manual

2.2 OPTIONAL ACCESSORIES SPECIFICATIONS

CUTTER SPECIFICATIONS
Media Type
Media Size
Thickness
Self-diagnosis function
Durability
DISPENSER SPECIFICATIONS
Media Type
Media Size
Thickness
Sensor Type
LINERLESS (NONSEPA) KIT SPECIFICATIONS
Media Type
Media Size
Thickness
Media Winding direction
Roll and core Diameter
Sensor Type
Label issuing mode
CG4 Series Service Manual
Pitch including liner: 25 to 303 mm (0.98" to 11.93")
Width including liner: 25 to 110 mm (0.98" to 4.33")
0.06 to 0.19 mm (0.0024" to 0.0074")
* Some restrictions may apply to some label types depending on the substrate,
adhesive, paper size, and environment. Refer to SATO representative on the
labels to be used.
* Perforated liner and split liner cannot be used.
* Peel end labels
Pitch including liner: 25 to 103 mm (0.98" to 4.05")
Width including liner: 25 to 110 mm (0.98" to 4.33")
0.06 to 0.19 mm (0.0024" to 0.0074")
Micro-perforated Linerless (Nonesepa) Label
0.06 to 0.19 mm (0.0024" to 0.0074")
Maximum outer diameter: 128 mm (5.04") with Inner core diameter: 40 mm (1.5")
Section 2: General Specifications
Non-adhesive paper and Label
Pitch: 22 to 300 mm (0.87" to 11.8")
Width: 22 to 107 mm (0.87" to 4.21")
Cutter error detection
More than 300,000 cuts
Label only
Pitch: 22 to 100 mm (0.86" to 3.93")
Width: 22 to 107 mm (0.86" to 4.21")
Dispenser sensor (Reflective type)
Pitch: 25 to 100 mm (0.98" to 3.93")
With: 25 to 110 mm (0.98" to 4.33")
Face-out
Label sensor (Reflective type)
Continuous mode, Tear-off mode
Page 2-7