Cover Sensor Replacement - SATO D508 Service Manual

COVER SENSOR REPLACEMENT

1 Turn the printer OFF and disconnect the power supply cord.
2 Lift up the top housing cover (1) (See Figure 4-9a) to access the sensor area.
3 Remove the two screws (2) securing the cable cover (3) to the top housing cover (1).
4 Remove the screw (4) that secures the cover sensor (5) to the top housing cover (1).
3
2
5 Remove the base cover from the printer to access the main board (6) (See Figure 4-9b).
6 Remove the five screws (7) that secure the main board (6) to the printer (8).
7 Remove the main board (6) and disconnect all wiring harnesses of the defective cover-
open sensor.
8 Detach the defective sensor from the printer and route the replacement sensor in its place.
9 Connect the replacement sensor to the main board (6) and re-secure the board (6) to the
printer (8) using five screws (7).
Page 4-12
5
4
1
Figure 4-9a, Cover Sensor Replacement
SATO D508/D512 Service Manual