4.13 FACTORY ADJUSTMENT MODE (cont'd)
Procedures
5
Press the FEED/LINE
button to execute the
Gap sensor output
adjustment.
6
Press FEED/LINE button
to start test printing.
Press FEED/LINE button
to pause the test printing.
Press again to resume.
Notes:
•
Restart the printer by pressing the POWER off and then on, the setting is then saved.
•
If you missed the chance to release the FEED/LINE button in step 2 above, just keep holding the
FEED/LINE button and wait for the next cycle.
•
If you released the FEED/LINE button at the wrong ON LINE (POWER) indicator, just turn off the power
and restart the procedure.
•
If an error occurred during adjustment, open the top cover once. Then press the FEED/LINE button after
closing the top cover to restart the adjustment.
•
The printer will continuously print the Factory test labels until the FEED/LINE button is pressed. The
printing is paused and will resume printing if the FEED/LINE button is press again.
CG4 Series Service Manual
Printer status
The printer will feed at
least 3 labels to adjust
the Gap sensor auto-
matically.
The printer is paused
and is ready for the
Factory Test printing.
Factory Test Print start
and print continuously.
Factory Test Print
paused.
Section 4: Operation and Configuration
ON LINE (POWER)
indicator
Off
Green light
Off
Blinking green light
Off
Green light
Off
Blinking green light
ERROR
Buzzer
indicator
Page 4-25