SATO CG412DT Service Manual page 69

No. Category
22 RS-232C interface
*1
23
24
25
26
27 LAN interface *2
28 IEEE 1284 inter-
face *4
28 Non-standard code
29
30 Download
31
*1. Available for USB+RS-232C specification only.
*2. Available for USB+LAN specification only.
*3. Use SATO port or Port 9100 when sending print request from the printer driver.
*4. Available for IEEE1284+USB specification only.
*5. The printer will restart in specified mode.
CG4 Series Service Manual
Setting item
Baud rate
Data bit
Parity
Stop bit
Control
LAN mode
Buffer type
ACK width
Nonstandard code
switching
Nonstandard code
setting
Firmware download
Reboot mode *5
Section 4: Operation and Configuration
Setting contents
9600/19200/38400bps
7/8 bit
No parity/Odd number/Even number
1/2 bit
READY/BUSY control (single item buffer),
READY/BUSY control (multi buffer), Xon/Xoff,
Protocol for driver(STATUS4), STATUS3
Protocol for driver(STATUS4)Cyclic response *3
Protocol for driver(STATUS4)ENQ response *3
1 port connection/ENQ response(STATUS3)
Multi/ 1 item
010 to 200 (1=50ns)
Standard code/Nonstandard code
Nonstandard code settings for STX, ETX, ESC,
ENQ, CAN, NULL, OFFLINE
Download firmware from the host computer.
(1) Start up in program download mode
(Available in normal operation mode only)
(2) Start up in normal operation mode
(Available in program download mode only)
Page 4-31