SATO CG412DT Service Manual page 125

8.3 OPTIONAL ACCESSORIES - LINERLESS (NON SEPA) (cont'd)
4.
Turn over the printer in upright position, open the Top cover
and replace the existing platen roller with the Linerless
platen roller . Refer to Section 7.2 Platen Roller Replace-
ment for detailed procedure.
5.
Remove the lower front cover by lifting it upward.
6.
Attach the latches of the Linerless (Non sepa) kit onto the
holes located below the two sides of platen roller of the
printer.
Close the top cover and turn the printer over again, with
the Main PCB is facing upward.
7.
Connect the Linerless (Non sepa) kit's cable to the
OPTION connector on the MAIN PCB .
Route the Linerless (Non sepa) kit's cable through the
groove (circled) of the printer as shown.
8.
Assemble the Bottom Housing cover back to the printer
and secure with the three screws removed in step 1.
CAUTION:
Ensure that no cables are pinched between parts when
you are assembling the cover.
CG4 Series Service Manual
Section 8: Appendix
OPTION
Linerless
connector
(Non sepa)
kit's cable
MAIN PCB
Page 8-9